Section 4 – Implement an IPv6 based solution, given a network design and a set of requirements
QUESTION NO: 1
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? (Choose two.)
A. Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.
B. Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.
Host configuration options for IPv6 can be statically assigned only.
C. IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.
D. IPv4 and IPv6 addresses can be simultaneously assigned to a host but not to a router interface. E. IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.
QUESTION NO: 2
Refer to the exhibit. What is required to complete the IPv6 routing configurations shown? Select the best response.
A. Interface authentication must be configured.
B. The routing processes must be configured with an area ID.
C. IP unicast routing must be enabled.
D. IPv4 addresses must be applied to the interfaces.
QUESTION NO: 3
What are three IPv6 transition mechanisms? (Choose three)
QUESTION NO: 4
To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.)
QUESTION NO: 5
Pass4sure plans on migrating their network from IPv4 to IPv6 in the near future. Which three techniques can be used to transition from IPv4 to IPv6? (Select three)
A. Dual stack
C. Flow label
D. Mobile IP
E. 6to4 tunneling
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|