Section 4 – Implement an IPv6 based solution, given a network design and a set of requirements
QUESTION NO: 26
In IPv6, the interfaces running OSPF can be configured with multiple address prefixes. Which statement is true about the IPv6 addresses that can be included into the OSPF process?
Select the best response.
A. Specific addresses cannot be selected for importation into the OSPF process.
B. Specific addresses can be selected using an ACL.
C. Specific addresses can be selected using a route map.
D. Specific addresses can be selected using a prefix list.
QUESTION NO: 27
Refer to the exhibit. Routers R1 and R2 are IPv6 BGP peers that have been configured to support a neighbor relationship over an IPv4 internetwork. Which three neighbor IP addresses are valid choices to use in the highlighted section of the exhibit? (Choose three.)
QUESTION NO: 28
Refer to the exhibit. Based on the output from the show command on RT1which statement is true? Select the best response.
A. OSPFv3 uses global IPv6 addresses to establish neighbor adjacencies.
B. RT1 has a subnet mask of 64 bits.
C. RT1 has FastEthernet0/0 set as a DR for network type broadcast.
D. OSPFv3 uses Link-local addresses to establish neighbor adjacencies.
E. RT1 does not have a global IPv6 address set on FastEthernet0/0.
F. OSPFv3 uses IPv4 addresses to establish neighbor adjacencies.
QUESTION NO: 29
Your company has migrated to IPv6 in their network. Which three IPv6 notations represent the same address? (Select three)
QUESTION NO: 30
Which statement is true concerning 6to4 tunneling?
A. IPv4 traffic is encapsulated with an IPv6 header.
B. The edge routers can use any locally configured IPv6 address.
C. Hosts and routers inside a 6to4 site will need a special code.
D. An edge router must use IPv6 address of 2002::/16 in its prefix.
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|