642-902 Q&A – Mix Practice Questions (1-5)

Section 6 – Mix Practice Questions

QUESTION NO: 1
When policy-based routing (PBR) is being configured, which three criteria can the set command specify? (Choose three.)
A. all interfaces through which the packets can be routed
B. all interfaces in the path toward the destination
C. adjacent next hop router in the path toward the destination
D. all routers in the path toward the destination
E. all networks in the path toward the destination
F. type of service and precedence in the IP packets
Answer: ACF

Explanation:
Configuring Policy-Based Routing (PBR):
You can configure PBR by following these steps. Some of the steps may be omitted depending on your application for PBR. For this example, note the set condition options listed is step 3 (answers are bolded).

QUESTION NO: 2
Refer to the exhibit. On the basis of the partial configuration, which two statements are correct? (Choose two.)
2
A. Only routes matching 10.0.1.0/24 will be advertised out Ethernet 0. B. Only routes 10.0.1.0/24 will be sent out all interfaces.
C. Only routes 10.0.1.0/24 will be allowed in the routing table.
D. Only routes matching 10.0.0.0/8 will be advertised out Ethernet 0.
E. Only routes matching 10.0.0.0/8 will be advertised out interfaces other than Ethernet 0. F. All routes will be advertised out interfaces other than Ethernet 0.
Answer: AE

QUESTION NO: 3
Refer to the exhibit. ROUTE.com is planning to implement load balancing for traffic between host on the 172.16.10.0/24 and 172.16.20./24 networks. You have been asked to review the implementation plan for this project.
Which statement about the plan is true? Select the best response.
3 
A. It is complete as written.
B. It should include a task to configure multipath to equal a value of 2 on R1 and R4.
C. It should use a ping instead of a traceroute to validate that load balancing has been activated.
D. It should contain a task that documents the changes made to the configurations.
Answer: D

QUESTION NO: 4
Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up.
What did the TAC engineer configure incorrectly?
4 
Select the best response.
A. The crypto isakmp configuration is not correct.
B. The crypto map configuration is not correct.
C. The interface tunnel configuration is not correct.
D. The network configuration is not correct; network 172.16.1.0 is missing.
Answer: A

QUESTION NO: 5
Refer to the exhibit. ROUTE.com is planning to implement a secure OSPF network to support traffic between clients on the 172.16.10.0/24 network and the file server on the 172.16.20./24 network. You have been asked to review the implementation and verification plans.
Which statement about the plan is true? Select the best response.

1
A. It is complete as written.
B. It should include a task that verifies that the interarea routes are using the proper MED.
C. The plan should include a task that verifies that load sharing is active on the appropriate links.
D. The plan should include a task that verifies end-to-end connectivity between the clients and the file server.
Answer: D

Lead2pass Testking Pass4sure Actualtests Others
$99.99 $124.99 $125.99 $189 $29.99-$49.99
Up-to-Dated
Real Questions
Error Correction
Printable PDF
Premium VCE
VCE Simulator
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back

2 thoughts on “642-902 Q&A – Mix Practice Questions (1-5)

  1. Question 4 Answer should be both C & D?

    C – The crypto map statement is incorrectly applied to the tunnel interface
    D – Their is no network statement for the tunnel IP to allow eigrp neighbors to form

    A – The crypto isakmp policy is fine (using defaults, not defined)

    B – The crypto map config also looks fine

Comments are closed.