OSPF is configured on routers Indianapolis and Atlanta. Indianapolis’s S0/0 interface and Atlanta’s S0/1 interface are in Area 0. Atlanta’s Loopback0 interface is in Area 2.
Your task is to configure the following:
- Portland’s S0/0 interface in Area 1
- Indianapolis’s S0/1 interface in Area 1
- Use the appropriate mask such that ONLY Portland’s S0/0 and Indianapolis’s S0/1 could be in Area 1.
- Area 1 should not receive any external or inter-area routes (except the default route).
By increasing the first distant office, JS manufactures has extended their business. They configured the remote office router (R3) from which they can reach all Corporate subnets. In order to raise network stableness and lower the memory usage and broadband utilization to R3, JS manufactures makes use of route summarization together with the EIGRP Stub Routing feature. Another network engineer is responsible for the implementing of this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been missing.
Company Acan has two links which can take it to the Internet. The company policy demands that you use web traffic to be forwarded only to Frame Relay link if available and other traffic can go through any links. No static or default routing is allowed.
Acme is a small export company that has an existing enterprise network that is running IPv6 OSPFv3. Currently OSPF is configured on all routers. However, R4′s loopback address (FEC0:4:4) cannot be seen in R1′s IPv6 routing table. You are tasked with identifying the cause of this fault and implementing the needed corrective actions that uses OSPF features and does no change the current area assignments. You will know that you have corrected the fault when R4′s loopback address (FEC0:4:4) can be seen in the routing table of R1.
Some information of the Lab Requirement:
R2 is an ASBR for EIGRP 100 and OSPF AREA 24
R3 is an ASBR for EIGRP 100 and OSPF AREA 34
[note: so there are TWO separate areas on TWO separate ASBRS thus you need to do redistribution on R2 and R3