Free Download Pass4sure Cisco CCIE Data Center 350-080 Exam Questions

CCIE Data Center Written Exam: 350-080 Exam
350-080 Questions & Answers
Exam Code: 350-080
Exam Name: CCIE Data Center Written Exam
Q & A: 129 Q&As

QUESTION 1
In a configuration with redundant supervisors, how many IP addresses are required to configure
full remote access via management 0?
A. two IP addresses, one for each supervisor
B. three IP addresses, one virtual IP and one physical IP for each supervisor
C. one IP address that is shared among supervisors
D. none–management 0 will use the IP address from the first SVI that is created
Answer: C

QUESTION 2
VLAN configuration using DCNM can be completed by which two supported methods? (Choose
two.)
A. Copy and paste the VLAN, along with its VLAN ID, name, type, admin state, and admin status, from
one device to another.
B. Create a single VLAN or a range of VLANs.
C. A VLAN is created only after choosing File > Deploy to apply changes.
D. After a VLAN is created, it requires the state to be enabled.
E. Modify the existing VLAN by choosing Interface > VLAN > VLAN Settings.
Answer: AB

QUESTION 3
Enabling jumbo frame support on a Cisco Nexus 5500 Switch can be done through which
method?
A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy map
Answer: D

QUESTION 4
Which two statements about authentication settings for DCNM-LAN are true? (Choose two.)
A. If none of the authentication servers that are configured for the current authentication mode responds
to an authentication request, the DCNM-LAN server falls back to local authentication.
B. DCNM-LAN only supports TACACS+.
C. Each DCNM-LAN server will have the same device credentials.
D. Administering DCNM-LAN authentication settings requires an authentication license.
E. DCNM-LAN server users are local to the DCNM-LAN server.
Answer: AE

QUESTION 5
DCNM is capable of monitoring the network performance of a SAN. What are the three primary areas of this operation?
A. analyze traffic, device management, and network monitoring
B. DCNM-SAN, DCNM-LAN, and device manager
C. definition of flows, information collection, and data presentation
D. SNMP poll data, MIB analysis, and report generation
Answer: C

QUESTION 6
What is required for proper implementation of jumbo frame support on a Cisco Nexus 2000 Series
Fabric Extender?
A. The interface configured as FEX fabric requires the MTU to be set to jumbo.
B. The service policy must be applied to the system QoS.
C. The device defaults to jumbo frame support; no changes are required.
D. The switchport in the FEX interface must be set to MTU 9216.
Answer: B

QUESTION 7
DCNM device discovery is done by connecting to Cisco NX-OS devices and doing which three of
these? (Choose three.)
A. collecting the running configuration
B. raising the logging level to meet the minimum requirement
C. discovering all devices by default
D. discovering devices using multiple user accounts as long as they are administrator-level accounts
E. using LLDP to discover network adaptors
Answer: ABE

QUESTION 8
What does the mac packet-classify command do when applied to an interface configuration?
A. It enables MAC ACLs to be applied to only IP packets that enter the interface.
B. It enables MAC ACLs to be applied to only non-IP packets that enter the interface.
C. It enables MAC ACLs to be applied to all packets that enter the interface.
D. It enables MAC ACLs to be used for QoS settings.
Answer: C

QUESTION 9
In a virtual port channel (vPC) configuration, VRRP exhibits which characteristic?
A. VRRP does not work with vPC due to industry standard requirements
B. VRRP works with vPC in traditional active/standby modes
C. VRRP works with vPC in an active/active mode
D. VRRP work with vPC as long as vPC peer-gateway is configured to address non-standard replies
to the physical MAC address
Answer: C

QUESTION 10
On Cisco Nexus 5000 Series Switches, where are the virtual output queues implemented, and
what is the main purpose of virtual output queues?
A. on all ingress interfaces; to ensure maximum throughput on a per-egress, per-CoS basis
B. on all ingress interfaces; to provide independent congestion management and 16 queues
C. on all egress interfaces; so that a congested egress port does not affect traffic directed to other
egress ports
D. on all egress interfaces; to prevent head-of-line blocking by utilizing multiple virtual output queues
E. on all egress interfaces; to be able to use EEE 802.1p CoS
Answer: A

QUESTION 11
Refer to the exhibit. Fabric Interconnect A, operating in end-host mode, receives an ingress frame
with source MAC address 0025.b500.0035 on uplink Eth1/19.
Which statements are true? (Choose two.)
A. The frame will be accepted. Fabric Interconnect A will update its MAC address table to show that
0025.b500.0035 is dynamically learned on Eth1/19 and no longer dynamically learned on Eth5/1/6.
B. Fabric Interconnect A will transmit a Gratuitous ARP for 0025.b500.0035 since it has moved ports,
and the upstream network needs to be notified of the new location.
C. Fabric Interconnect A will drop the frame.
D. The MAC address table will not be updated as a result of receiving this frame on an uplink.
E. Reverse Path Forwarding will determine whether or not this frame is dropped by Fabric Interconnect A.
F. Deja vu will determine whether or not this frame is dropped by Fabric Interconnect A.
Answer: CD

QUESTION 12
A Cisco UCS fabric interconnect in end-host mode learns MAC addresses on which port types?
(Choose four.)
A. Uplink Ethernet ports or border ports
B. Appliance ports
C. Server ports
D. Fabric ports
E. Backplane ports
F. vEth interfaces
G. A Fabric Interconnect doesn’t learn MAC addresses in End Host mode. Pinning is used instead.
Answer: BCEF

QUESTION 13
On the Cisco Nexus 7000 Series Switch, Control Plane Policing is enforced on which component?
A. The supervisor module enforces CoPP before out-of-policy traffic reaches the CPU
B. The fabric modules enforce CoPP in the fabric before out-of-policy traffic reaches the CPU
C. The linecards enforce CoPP locally before out-of-policy traffic reaches the CPU
D. The egress virtual output queue enforces CoPP locally before out-of-policy traffic reaches the CPU
Answer: C

QUESTION 14
What is the benefit of using Anycast RP via RFC 4610 for IP multicast RP redundancy?
A. Improves convergence of the multicast network due to enhanced RPF checks
B. Simplifies the number of control plane protocols over other RP redundancy methods
C. Eliminates the use of Protocol Independent Multicast (PIM) in the topology
D. Increases the administrative distances in Multicast Source Discovery Protocol (MSDP) configuration
Answer: B

…go to http://www.lead2pass.com/350-080.html to download the full version Q&As.

Lead2pass Testking Pass4sure Actualtests Others
$99.99 $124.99 $125.99 $189 $29.99-$49.99
Up-to-Dated
Real Questions
Error Correction
Printable PDF
Premium VCE
VCE Simulator
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back