642-902 Q&A

Free Download Pass4sure Cisco CCENT 642-902 Exam Questions

Implementing Cisco IP Routing (ROUTE): 642-902 Exam
642-902 Questions & Answers
Exam Code: 642-902
Exam Name: Implementing Cisco IP Routing (ROUTE)
Q & A: 394 Q&As

QUESTION 1
Which show command will display the two values used in the calculation of the EIGRP metric?
A. show protocol
B. show ip eigrp interface
C. show interface
D. show ip eigrp neighbor
Answer: B

Continue reading

642-902 Q&A – Mix Practice Questions (16-20)

Section 6 – Mix Practice Questions

QUESTION NO: 16
What is the purpose of configuring the router as a PPPoE client? Select the best response.
A. to provide VPN access over L2TP
B. to enable PPP session from the router to the termination device at the headend for metro Ethernet connectivity
C. for DSL connectivity and removing the need for the end-user PC to run the PPPoE client software
D. for connecting the router to a cable modem, which bridges the Ethernet frames from the router to the cable modem termination system
Answer: C

Continue reading

642-902 Q&A – Mix Practice Questions (1-5)

Section 6 – Mix Practice Questions

QUESTION NO: 1
When policy-based routing (PBR) is being configured, which three criteria can the set command specify? (Choose three.)
A. all interfaces through which the packets can be routed
B. all interfaces in the path toward the destination
C. adjacent next hop router in the path toward the destination
D. all routers in the path toward the destination
E. all networks in the path toward the destination
F. type of service and precedence in the IP packets
Answer: ACF

Continue reading

642-902 Q&A Index (Section 4 – Implement an IPv6 based solution)

Section 4 – Implement an IPv6 based solution, given a network design and a set of requirements

• Determine network resources needed for implementing IPv6 on a network
• Create an IPv6 implementation plan
• Create an IPv6 verification plan
• Configure IPv6 routing
• Configure IPv6 interoperation with IPv4
• Verify IPv6 solution was implemented properly using show and debug commands
• Document results of IPv6 implementation and verification plan

Continue reading

642-902 Q&A – Implement an IPv6 based solution (31-35)

Section 4 – Implement an IPv6 based solution, given a network design and a set of requirements

QUESTION NO: 31
What are two rules for compacting IPv6 addresses? (Choose two.) Select 2 response(s).
A. The maximum number of times a double colon can replace a 16-bit segment that consists of all zeroes is two.
B. The leading zeroes in any 16-bit segment do not have to be written.
C. Every 16-bit segment that consists of all zeroes can be represented with a single colon.
D. The trailing zeroes in any 16-bit segment do not have to be written.
E. Any single, continuous string of one or more 16-bit segments that consists of all zeroes can be represented with a double colon.
F. Two zeroes in the middle of any 16-bit segment do not have to be written.
Answer: BE

Continue reading

642-902 Q&A – Implement an IPv6 based solution (26-30)

Section 4 – Implement an IPv6 based solution, given a network design and a set of requirements

QUESTION NO: 26
In IPv6, the interfaces running OSPF can be configured with multiple address prefixes. Which statement is true about the IPv6 addresses that can be included into the OSPF process?
Select the best response.
A. Specific addresses cannot be selected for importation into the OSPF process.
B. Specific addresses can be selected using an ACL.
C. Specific addresses can be selected using a route map.
D. Specific addresses can be selected using a prefix list.
Answer: A

Continue reading

Pages: 1 2 3 4 5 6